Isuzu Tilt Slide FYJ2000 Instruction Manual page 191

Windshield Wiper and Windshield Washer Switch
To use the windshield wiper and washer switches, the starter switch must be in the
"ON" position.
Lever
position
Wiper state Stop
CONTROLS AND INSTRUMENTS
Windshield Wiper Switch
The windshield wiper switch has the
following positions, which correspond to the
states of the wiper.
Intermittent
(Light rain)
ADVICE
• The safety system may work to stop
the wiper when excessive load is
applied on the motor. In this case,
turn the switch to the "OFF" position
and, a few minutes later, check to
see if the wiper is back to normal
operation. If the wiper frequently
stops operation, refrain from using
it and contact the nearest Isuzu
Dealer.
• Before operating the wiper, ensure
that the wiper rubber is not stuck on
to the windshield. If the wiper rubber
is stuck on to the windshield and
you still operate the wiper, the wiper
may break or the wiper motor may
fail.
• Do not operate the wiper on a dry
windshield surface. Otherwise, the
windshield surface may sustain
damage. Always use the windshield
washer when wiping a dry glass
surface.
—
Low speed
(Moderate rain)
4-63
=
High speed
(Heavy rain)