Isuzu Tilt Slide FYJ2000 Instruction Manual page 554

8-26
IN CASE OF EMERGENCY
When the bulb has blown out, replace it with a bulb of the specified wattage. Be careful
not to excessively tighten the screws when installing.
ADVICE
• Do not replace a bulb with other than the specified wattage. This will cause
abnormal flashing, particularly for turn signal lights.
• When replacing headlight bulbs, have the headlight aim adjusted at the nearest
Isuzu Dealer.
CAUTION
• Tilt the cab only on a level surface.
• Check the areas in front of and above the cab for sufficient clearance when
tilting the cab indoors.
• When tilting the cab, close the doors securely. You should avoid opening or
closing the doors when the cab is tilted.
• Do not tilt the cab when objects are placed on or in the instrument panel, seats,
cup holders or on floor.
• Remove any ice or snow accumulating on the top of the bumper before tilting
the cab. Failure to do so could damage the bumper, headlights, back panel tray
or other components.
• When you must unavoidably open or close a tilted cab's door, securely support
the weight of the door while opening or closing it. It is dangerous to release the
door from your hand when it is being opened or closed. The door could hit you
or someone and cause an injury or the door could be damaged. Confirm that
the door is completely shut after closing it.
Replacing the Headlights
Bulb Wattage→ Refer to page 8-24
1. Tilt the cab and work from
front-sideways of the vehicle for the
replacement.
Tilting the Cab→ Refer to page 7-10