Isuzu Tilt Slide FYJ2000 Instruction Manual page 410

7-82
SERVICE AND MAINTENANCE
The two disc wheels are tightened with
one rear nut, so be sure to jack up both
of the dual tyres.
1. Firmly apply the parking brake. When
changing a front wheel, chock the rear
wheel diagonally opposite to the front
wheel. When changing a rear wheel,
chock the front wheel diagonally
opposite to the rear wheel.
2. Firmly apply the head of the jack to
the jacking point.
3. Raise the vehicle enough so that the
tyre is not quite clear of the ground.
4. Using a wheel wrench, loosen the
wheel nuts just enough so that the
wheel remains stable in position. Do
not remove the wheel nuts yet.
CAUTION
• Both the left and right wheels have
right-handed threads.
• Do not loosen the wheel nuts too
much. The wheel bolts would be
damaged.
• Use a tyre of the specified size and
the same tread pattern as the one to
be replaced.
5. Jack up the vehicle so that the tyre is
clear of the ground completely.
6. Remove all of the loosened wheel
nuts, remove the outer tyre, and then
remove the inner tyre.
When removing the tyre, take care not
to damage the threads of the wheel
bolts and the disc wheel mounting
face of the hub.