Isuzu Tilt Slide FYJ2000 Instruction Manual page 432

7-104
SERVICE AND MAINTENANCE
MJT7 model transmission
ZF9S1310 or RTO-11908LL model
transmission
Clutch Booster Exhaust Cover
5. Press the clutch pedal several times
and then keep it pressed.
6. Loosen the bleeder screw to let the
clutch fluid containing air bubbles flow
into the container and then tighten the
bleeder screw immediately.
7. Release the clutch pedal slowly.
Repeat Steps 5 and 6 until the fluid
from the tube no longer contains air
bubbles. After bleeding, install the
rubber cap in position.
CAUTION
• While bleeding, ensure that the fluid
level in the clutch fluid tank is not
below the "MIN" line.
Remove and clean the clutch booster
exhaust cover according to the
maintenance schedule.
Maintenance Schedule
→ Refer to page 7-163