Isuzu Tilt Slide FYJ2000 Instruction Manual page 462

7-134
SERVICE AND MAINTENANCE
WARNING
• When jacking up the vehicle, select a flat, solid surface.
• After raising the vehicle and before going underneath to perform work, make
sure the vehicle is supported with jack stands.
• Do not start the engine when the vehicle is jacked up. The resulting vibration
may cause the jack to slip out of place.
• When jacking up the vehicle, stop the engine and place the starter switch in the
"LOCK" position. If the starter switch is in the "ACC" or "ON" position, the vehicle
height may rise or fall while it is jacked up, which is extremely dangerous.
• Before starting a jacking operation, ensure that the jack and the jacking point to
be used are clear of dirt, oil and grease. Failure to observe this precaution can
lead to extremely dangerous situations such as entrapment beneath the vehicle
should the dirt or oil cause the jack to slip.
• For vehicles equipped with a differential lock, do not turn a wheel that has its
opposite wheel on the ground. If you turn the wheel that is jacked up, drive force
will be transmitted to the wheel on the ground. The vehicle may move, which
would be extremely dangerous.
Jack head
Socket
Handling the Jack
Operating the Jack
Release valve
HCU7C0SH010101
Raising the Vehicle
1. Place the jack immediately below
the jacking point and ensure that it is
upright.
The jack must be placed on a flat,
solid surface.
Jacking Points → Refer to page 7-136