Isuzu Tilt Slide FYJ2000 Instruction Manual page 449

FYH model
SERVICE AND MAINTENANCE
3. Without running the engine, fully turn
the steering wheel in both directions a
few times.
4. Lower the vehicle and start the
engine. While running the engine at
idle, fully turn the steering wheel in
both directions a few times. If you do
not hear abnormal sounds any more,
the system has been properly bled.
CAUTION
• While refilling the system, keep
the fluid tank full of fluid by making
additions as necessary to prevent
air from getting into the hydraulic
system.
Bleeding
If an unusual noise is emitted when you
turn the steering wheel, it means that
there is air in the hydraulic system. Carry
out an air bleed according to the following
procedure.
1. Apply the parking brake firmly and
chock the rear wheels.
2. Raise the vehicle until the front
wheels are completely clear of the
ground.
3. Without running the engine, fully turn
the steering wheel in both directions a
few times.
7-121