Isuzu Tilt Slide FYJ2000 Instruction Manual page 213

Upshift Procedure
Lo-Lo to Lo...
1. Move the deep reduction selector to the "Out" position and immediately release
the accelerator pedal, depress the clutch pedal once to break torque, and re-
engage the clutch. The transmission shifts from deep reduction to Lo range when
synchronous is reached. Then accelerate.
Range Shift - Lo to Hi range (4th to 5th)...
2. When in last gear position for Lo range and ready for the next upshift, pull up
the range selector and move the shift lever, double-clutching, to the next higher
speed position according to your shift pattern. As the shift lever passes through
neutral, the transmission will automatically shift from Lo to Hi range.
CAUTION
• Never move the shift lever to the Lo speed gear position after Hi range
preselection, or at anytime the transmission is in Hi range.
CONTROLS AND INSTRUMENTS
6. Make sure the deep reduction selector
is in the "Out" position. OR, in the "In"
position if you want to start in Lo-Lo
under adverse conditions.
7. Depress the clutch pedal to the floor.
8. Move the shift lever to desired initial
gear.
9. Release the parking brakes on the
vehicle.
10. Slowly release the clutch pedal and
apply accelerator.
4-85