Isuzu Tilt Slide FYJ2000 Instruction Manual page 435

Oil
surface
SERVICE AND MAINTENANCE
Level
plug hole
Oil level
(bottom face of
screw hole)
HCU7C0SH005201
Oil strainer plug tightening torque
64 - 88 N·m (6.5 – 9.0 kgf·m/47 - 65 lb·ft)
Drain plug tightening torque
(other than above)
49 - 88 N·m (5.0 - 9.0 kgf·m/36 - 65 lb·ft)
3. After the drain plug is installed, add
the oil from the level plug hole, up to
the lower edge of the hole.
4. After refilling, confirm that the oil level
is up to the lower edge of the oil level
plug hole.
5. Install the oil level plug to the
specified torque.
Oil level plug tightening torque
49 - 88 N·m (5.0 - 9.0 kgf·m/36 - 65 lb·ft)
6. For a vehicle equipped with a
transmission oil cooler, drive the
vehicle for 2 or 3 minutes or idle it for
at least 5 minutes to allow the oil to
flow into the piping.
Stop the engine, and after the air
bubbles in the transmission have
disappeared, remove the level plug
again and add the oil up to the lower
edge of the level plug hole.
Install the level plug by tightening to
the specified torque.
Oil level plug tightening torque
49 - 88 N·m (5.0 - 9.0 kgf·m/36 - 65 lb·ft)
7-107