Isuzu Tilt Slide FYJ2000 Instruction Manual page 457

Clutch booster joint pin
1 position on the right side
Lubricate directly around the pin (without grease fitting).
(MJT7 transmission vehicles)
ADVICE
• At points where multi-purpose type grease is used, do not mix another type of
grease (chassis grease. etc.) with the multi-purpose type grease. Be sure to
use only multi-purpose type grease. If you use chassis grease, the bearing may
become damaged.
• Each of propeller shaft universal joints must be greased liberally until grease
oozes at the 4 needle bearing oil seal locations. After greasing, wipe away any
grease that has oozed out.
Apply multi-purpose type grease to the following points according to the maintenance
schedule.
Drag link
[multi-purpose type grease]
2 points front and rear
SERVICE AND MAINTENANCE
Steering shaft sliding sleeve
[multi-purpose type grease]
[Inside cab] 1 point: Place the steering
wheel in the straight forward position and
apply grease.
7-129