Isuzu Tilt Slide FYJ2000 Instruction Manual page 414

7-86
SERVICE AND MAINTENANCE
Wheel nut tightening sequence
ADVICE
• After changing a tyre, turn the steering wheel in both directions to make sure
that the wheels do not interfere with the surrounding components. If you are
unclear about any of this, please contact the nearest Isuzu Dealer.
• The tightening torque of the wheel nuts may decrease after tire replacement
due to their initial settlement. After driving 50 to 100 km (31 to 62 miles), be sure
to retighten the wheel nuts to the specified torque.
5. When installing the rear wheels, place
the outer wheel so that its tyre air
valve will be away from that of the
inner wheel to enable inflating both
inner and outer tyres.
6. Install the wheel nuts, and tighten
them to the extent that the tyres do
not wobble about.
7. Turn the release valve of the jack
counterclockwise and slowly lower the
vehicle.
8. Tighten the wheel nuts in a diagonal
sequence and in two or three passes.
9. Finally, tighten all wheel nuts using a
torque wrench to the specified torque.
Wheel nut tightening torque
500 - 550 N·m
(50 - 55 kgf·m/362 - 398 lb·ft) (Wet)
Retightening Wheel Nuts (ISO 10-bolt
Wheels) → Refer to page 7-87