Isuzu Tilt Slide FYJ2000 Instruction Manual page 375

SERVICE AND MAINTENANCE
8. Slowly tighten the element case with
a filter wrench until it touches the filter
body.
9. Tighten the drain plug, connect the
water separator switch connector,
then bleed the fuel system.
Bleeding the Fuel System
10. After changing the fuel filter, operate
the engine and check there are no
leaks around the filter.
11. After changing the fuel filter, racing
the engine about two minutes (about
1,300 r/min), and fill both fuel filters
with diesel fuel.
CAUTION
• Since the clear element case is
made of plastic, applying clear
lacquer or other organic solvents to
the case could cause cracks (fuel
leakage). Do not apply paint or the
like to the case.
• Clean any foreign matter or dirt from
the bottom of the clear element
case and check that the float moves
freely and smoothly.
• Use only an Isuzu genuine fuel filter.
• Replace the O-ring when replacing
the filter.
• Dispose of the replaced filter in
compliance with the regulatory
requirements in your country.
→ Refer to page 8-13
ADVICE
7-47