Isuzu Tilt Slide FYJ2000 Instruction Manual page 434

7-106
SERVICE AND MAINTENANCE
RTO-11908LL model transmission
Changing the Transmission Oil (MJT7 Model Transmission)
ADVICE
• Any dirt on the plug should be wiped off before removing or installing it.
• Since the case of the MJT model transmission is made of aluminum, be
extremely careful not to tighten the plug excessively when installing the level
plug. Tightening to a torque larger than the one specified may damage the
threaded portion.
• Drained oil must be disposed of in a method conforming to the regulatory
requirement in your country.
1. Place a container under the drain plug
to receive oil.
2. Remove both the level plug and drain
plug to discharge the oil. Also, remove
the drain plug on the transmission
rear cover.
Take off the plug at the front section
of transmission to remove the oil
strainer, wash it with light oil, dry or
air-blow it, and then reinstall it.
Be sure to wipe away any dirt on the
drain plug and then reinstall the plug
by tightening to the specified torque.