Recall; State - Agilent Technologies X Series Manual

System Functions

Recall

Recall
Accesses a menu that enables you to select the information that you want to recall.
The options are State, Trace and Data. (screen images can be saved, but not recalled.) The default paths
for Recall are data type dependent and are the same as for the Save key.
Key Path
Notes
Initial S/W Revision

State

Accesses a menu that enables you to recall a State that has previously been saved. Recalling a saved state
returns the analyzer as close as possible to the mode context and may cause a mode switch if the file
selected is not for the current active mode. A State file can be recalled from either a register or a file.
Once you select the source of the recall in the State menu, the recall will occur.
See "More Information" on page
Key Path
Mode
Example
Notes
Initial S/W Revision
More Information
In measurements that support saving Traces, for example, Swept SA, the Trace data is saved along with
the State in the State file. When recalling the State, the Trace data is recalled as well. Traces are recalled
exactly as they were stored, including the writing mode and update and display modes. If a Trace was
updating and visible when the State was saved, it will come back updating and visible, and its data will
be rewritten right away. When you use State to save and recall traces, any trace whose data must be
preserved should be placed in View or Blank mode before saving.
116
Front-panel key
No remote command directly controls the Recall Type that this key controls.
The Recall type is a node in the :MMEM:LOAD command. An example is
:MMEM:LOAD:STATe <filename>.
Prior to A.02.00
116.
Recall
All
MMEM:LOAD:STAT "MyStateFile.state"
This loads the state file data (on the default file directory path) into the
instrument state.
See "Open" on page 119.
Prior to A.02.00