Agilent Technologies X Series Manual page 458

Input/Output
Trig Out (1 and 2)
Select the type of output signal that will be output from the rear panel Trig 1 Out or Trig 2 Out
connectors.
Key Path
Remote Command
Example
Dependencies
Preset
State Saved
Initial S/W Revision
Off
Selects no signal to be output to the Trig 1 Out or Trig 2 Out connector.
Key Path
Example
Readback
Initial S/W Revision
Polarity
Sets the output to the Trig 1 Out or Trig 2 Out connector to trigger on either the positive or negative
polarity.
Key Path
Remote Command
458
Input/Output, Output Config
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut
HSWP|MEASuring|MAIN|GATE|GTRigger|OEVen|SPOint|SSWeep|S
SETtled|S1Marker|S2Marker|S3Marker|S4Marker|OFF
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut?
TRIG:OUTP HSWP
TRIG2:OUTP GATE
The second Trigger output (Trig 2 Out) does not appear in all models; in
models that do not support it, the Trig 2 Out key is blanked, and sending the
SCPI command for this output generates an error, "Hardware missing; Not
available for this model number" In models that do not support the Trigger 2
output, this error is returned if trying to set Trig 2 Out and a query of Trig 2
Out returns OFF.
Trigger 1: Sweeping (HSWP)
Trigger 2: Gate
This is unaffected by a Preset but is preset to the above values on a "Restore
Input/Output Defaults" or "Restore System Defaults->All"
Saved in instrument state
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
TRIG1:OUTP OFF
Off
Prior to A.02.00
Input/Output, Output Config, Trig 1/2 Output
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity
POSitive|NEGative
:TRIGger|TRIGger1|TRIGger2[:SEQuence]:OUTPut:POLarity?