Marker X Axis Value (Remote Command Only); Marker X Axis Position (Remote Command Only) - Agilent Technologies X Series Manual

Initial S/W Revision

Marker X Axis Value (Remote Command Only)

Sets the marker X Axis value in the current marker X Axis Scale unit. It has no effect if the control mode
is but is the SCPI equivalent of entering an X value if the control mode is
Off,
Mode
Remote Command
Example
Notes
Preset
State Saved
Range
Initial S/W Revision

Marker X Axis Position (Remote Command Only)

Sets the marker X position in trace points. It has no effect if the control mode is
equivalent of entering a value if the control mode is
X Axis Scale units. The entered value is immediately translated into the current X Axis Scale units for
setting the value of the marker.
Mode
Remote Command
Prior to A.02.00
BASIC
:CALCulate:SPECtrum:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:
X <freq>
:CALCulate:SPECtrum:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:
X?
CALC:SPEC:MARK3:X 100
CALC:SPEC:MARK3:X?
If no suffix is sent it uses the fundamental units for the current marker X Axis
Scale. If a suffix is sent that does not match the current marker X Axis Scale
unit, an error "Invalid suffix" is generated.
The query returns the marker's absolute X Axis value if the control mode is
Normal , or the offset from the marker's reference marker if the control mode
is Delta . The query is returned in the fundamental units for the current marker
X Axis scale: Hz for
Frequency
. If the marker is
Time Off
You must be in the IQ Analyzer (Basic) mode to use this command. Use
INSTrument:SELect to set the mode.
After a preset, all markers are turned OFF, so Marker X Axis Value query
returns a not a number (NAN).
No
Depends on X axis range of selected Trace.
Prior to A.02.00
Normal
BASIC
:CALCulate:SPECtrum:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:
X:POSition <freq>
:CALCulate:SPECtrum:MARKer[1]|2|3|4|5|6|7|8|9|10|11|12:
X:POSition?
Complex Spectrum Measurement
Normal
and , seconds for
Inverse Time
the response is not a number.
Off,
or Delta - except in trace points rather than
Marker
or .
Delta
and
Period
but is the SCPI
231