Presel Center; Presel Adjust - Agilent Technologies X Series Manual

Complex Spectrum Measurement
AMPTD Y Scale
Remote Command
Example
Notes
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision

Presel Center

When this key is pressed, the centering of the preselector filter is adjusted to optimize the amplitude
accuracy at the center frequency. This key does not appear in model numbers that do not contain an
internal preselector (such as option 503 or all versions of the N9000A). Attempts to set via SCPI will be
accepted without error. Queries will always return 0.
See "Presel Center" on page 368
This is only available when the selected input is RF.
Key Path

Presel Adjust

Enables you to manually adjust the preselector filter frequency to optimize its response to the signal of
interest. This function is only available when Presel Center is available.
This key does not appear in model numbers which do not contain an internal preselector (such as option
503 or all versions of the N9000A). Attempts to set via SCPI will be accepted without error. Queries will
always return 0.
See "Preselector Adjust" on page 369
This is only available when the selected input is RF.
Key Path
222
:DISPlay:SPECtrum:VIEW[1]:WINDow2:TRACe:Y[:SCALe]:PDIVi
sion <voltage>
:DISPlay:SPECtrum:VIEW[1]:WINDow2:TRACe:Y[:SCALe]:PDIVi
sion?
DISP:SPEC:VIEW:WIND2:TRAC:Y:PDIV 10
DISP:SPEC:VIEW:WIND2:TRAC:Y:PDIV?
You must be in the IQ Analyzer (Basic) mode to use this command. Use
INSTrument:SELect to set the mode.
When you set a value manually, Auto Scaling automatically changes to Off.
When Auto Scaling is turned on, this value is automatically determined by the
measurement result.
100.0 mV
Saved in instrument state.
1.00 nV
20.0 V
Prior to A.02.00
for more information
AMPTD/Y Scale
for more information.
AMPTD/Y Scale