Agilent Technologies X Series Manual page 196

System Functions
System
Confirmation is required to restore the factory default values. The confirmation dialog is:
Key Path
Example
Initial S/W Revision
Restore Align Defaults
This selection causes the Alignment system settings to be a reset to their default values. This does not
affect any Alignment data stored in the system. This level of Restore System Defaults does not affect any
other system settings, mode settings and does not cause a mode switch.
After performing this function, it may impact the auto-alignment time of the instrument until a new
alignment baseline has been established.
Confirmation is required to restore the factory default values. The confirmation dialog is:
Key Path
Example
Initial S/W Revision
196
System, Restore System Defaults
:SYST:DEF PON
Prior to A.02.00
System, Restore System Defaults
:SYST:DEF ALIG
Prior to A.02.00