Agilent Technologies X Series Manual page 444

Input/Output
Dependencies
Preset
State Saved
Initial S/W Revision
dBµV/m
Sets the antenna unit to dBµV/m. If this correction is turned on, and Apply Corrections is on, the Y Axis Unit will
then be forced to dBµV/m and all other Y Axis Unit selections will be grayed out.
Key Path
Example
Readback
Initial S/W Revision
dBµA/m
Sets the antenna unit to dBµA/m. If this correction is turned on, and Apply Corrections is on, the Y Axis Unit will
then be forced to dBµA/m and all other Y Axis Unit selections will be grayed out.
Key Path
Example
Readback
Initial S/W Revision
dBpT
Sets the antenna unit to dBpT. If this correction is turned on, and Apply Corrections is on, the Y Axis Unit will then
be forced to dBpT and all other Y Axis Unit selections will be grayed out.
Key Path
Example
Readback
Initial S/W Revision
dBG
Sets the antenna unit to dBG. If this correction is turned on, and Apply Corrections is on, the Y Axis Unit will then
be forced to dBG and all other Y Axis Unit selections will be grayed out.
444
Only the first correction array (Correction 1) supports antenna units.
Note that this means that a correction file with an Antenna Unit can only be
loaded into the Corrections 1 register. Consequently only for Correction 1
does the dropdown in the Recall dialog include.ant, and if an attempt is made
to load a correction file into any other Correction register which DOES
contain an antenna unit, a Mass Storage error is generated.
Unaffected by Preset. Set to NOC by Restore Input/Output Defaults
Saved in State
A.02.00
Input/Output, Corrections, Properties, Antenna Unit
:CORR:CSET2:ANT UVM
"dBµV/m"
A.02.00
Input/Output, Corrections, Properties, Antenna Unit
:CORR:CSET2:ANT UVA
" dBµA/m"
A.02.00
Input/Output, Corrections, Properties, Antenna Unit
:CORR:CSET3:ANT PTES
"dBpT"
A.02.00