Security - Agilent Technologies X Series Manual

Security

Accesses capabilities for operating the instrument in a security controlled environment.
Key Path
Initial S/W Revision
USB
The Windows operating system can be configured to disable write access to the USB ports for users who
are in a secure environment where transferring data from the instrument is prohibited. This user interface
is a convenient way for the customer to disable write access to USB.
Key Path
Mode
Scope
Remote Command
Example
Notes
Dependencies
Preset
State Saved
Range
Initial S/W Revision
Read-Write
Selection for allowing full read-write access to the USB ports.
Key Path
Example
Initial S/W Revision
Read only
Selection for disabling write access to the USB ports.
Key Path
System
A.04.00
System, Security
All
Mode Global
:SYSTem:SECurity:USB:WPRotect[:ENABle] ON|OFF|0|1
:SYSTem:SECurity:USB:WPRotect[:ENABle]?
:SYST:SEC:USB:WPR ON
When the USB ports are in Read-only mode then no data can be stored to
USB, including the internal USB memory used for a back-up location for the
calibration data.
This key is grayed-out unless the current user has administrator privileges.
This is unaffected by Preset or any Restore System Defaults. An Agilent
Recovery will set the USB to write protect OFF
No
Read-Write|Read only
A.04.00
System, Security, USB
:SYST:SEC:USB:WPR OFF
A.04.00
System, Security, USB
System Functions
Will set USB ports to Read-only
Will set USB ports to Read-Write
System
203