Advanced - Agilent Technologies X Series Manual

Couplings
Readback
Initial S/W Revision
Best Wide-offset P Noise
The LO phase noise is optimized for wider offsets from the carrier. Closer offsets are compromised and
the throughput of measurements (especially remote measurements where the center frequency is
changing rapidly), is reduced.
Key Path
Example
Couplings
Readback
Initial S/W Revision

Advanced

Opens a menu of advanced settings for the complex spectrum measurement.
Key Path
Initial S/W Revision
The frequency below which the phase noise is optimized is model dependent:
CXA: n/a
EXA: [offset 150 kHz]
MXA: [offset 150 kHz]
PXA: [offset 400 kHz]
Close-in.
If manually selected the "Man" will be underlined. The actual frequency
offset within which noise is optimized is shown with in square brackets, as
this can vary depending on the hardware set in use. For example, in some
analyzers this annotation appears as [offset <140 kHz]
Prior to A.07.00
Meas Setup, PhNoise Opt
SPEC:FREQ:SYNT 2
The frequency below which the phase noise is optimized is model dependent:
CXA: n/a
EXA: [offset >150 kHz]
MXA: [offset >150 kHz]
PXA: [offset >400 kHz]
Wide-offset.
If manually selected the "Man" will be underlined. The actual frequency
offset beyond which noise is optimized is shown with in square brackets, as
this can vary depending on the hardware set in use. For example, in some
analyzers this annotation appears as [offset >160 kHz]
Prior to A.07.00
Meas Setup
Prior to A.02.00
Complex Spectrum Measurement
Meas Setup
247