Ref Value (Waveform View) - Agilent Technologies X Series Manual

Max
Initial S/W Revision

Ref Value (Waveform View)

Sets the horizontal scale reference value in the waveform view window.
Key Path
Mode
Remote Command
Example
Notes
Couplings
Preset
State Saved
Min
Max
Initial S/W Revision
Hardware Dependent:
RF Input:
No Option = 8.0 MHz
Option B25 = 25.0 MHz
Option B40 = 40.0 MHz
Option B1X = 140.0 MHz
I/Q Input:
No Option = 10.0 MHz per channel (20.0 MHz for I+jQ)
Option B25 = 25 MHz per channel (50 MHz for I+jQ)
Option S40 = 40 MHz per channel (80 MHz for I+jQ)
Prior to A.02.00
SPAN X Scale
BASIC
:DISPlay:SPECtrum:VIEW[1]:WINDow2:TRACe:X[:SCALe]:RLEVe
l <time>
:DISPlay:SPECtrum:VIEW[1]:WINDow2:TRACe:X[:SCALe]:RLEVe
l?
DISP:SPEC:VIEW:WIND2:TRAC:X:RLEV 10
DISP:SPEC:VIEW:WIND2:TRAC:X:RLEV?
You must be in the IQ Analyzer (Basic) mode to use this command. Use
INSTrument:SELect to set the mode.
If the Auto Scaling is set to On, this value is automatically determined by the
measurement result. When you set this value manually, Auto Scaling
automatically changes to Off.
0.000 s
Saved in instrument state.
–1.00 s
10.00 s
Prior to A.02.00
Complex Spectrum Measurement
Span X Scale
271