Programming the Analyzer
IEEE Common GPIB Commands
Self Test Query
This query performs the internal self-test routines and returns a number indicating the success of the
testing. A zero is returned if the test is successful, 1 if it fails.
Remote Command
Example
Initial S/W Revision
Wait-to-Continue
This command causes the instrument to wait until all overlapped commands are completed before
executing any additional commands. There is no query form for the command.
Remote Command
Example
Status Bits/OPC dependencies
Initial S/W Revision
104
*TST?
*TST? Runs the self-test routines and returns 0=passed, 1=some part failed.
Prior to A.02.00
*WAI
INIT:CONT OFF; INIT;*WAI Sets the instrument to single sweep. Starts a
sweep and waits for its completion.
Not global to all remote ports or front panel. *OPC only considers operation
that was initiated on the same port as the *OPC command was issued from.
Prior to A.02.00
Chapter 4