Remote Command
Example
Preset
State Saved
Min
Max
Initial S/W Revision
Default Unit
System Display Settings
These settings are "Mode Global" – they affect all modes and measurements and are reset only by
Restore Misc Defaults
Key Path
Initial S/W Revision
Annotation Local Settings
This is a Mode Global override of the meas local annotation settings. When it is
Annotation, Meas Bar, Trace, and Active Function Values
all modes. This provides the security based "annotation off" function of previous analyzers; hence it uses
the legacy SCPI command.
When it is
the
All Off,
Screen, Meas Bar, Trace,
Annotation
menu are grayed out and forced to
the local annotation settings on a measurement by measurement basis.
Key Path
Remote Command
Example
Preset
:DISPlay:WINDow[1]:TRACe:Y:DLINe <ampl>
:DISPlay:WINDow[1]:TRACe:Y:DLINe?
:DISPlay:WINDow[1]:TRACe:Y:DLINe:STATe OFF|ON|0|1
:DISPlay:WINDow[1]:TRACe:Y:DLINe:STATe?
DISP:WIND:TRAC:Y:DLIN:STAT ON
DISP:WIND:TRAC:Y:DLIN:STAT –32 dBm
Set the Display Line to Off and –25 dBm on Preset. When the Display Line
goes from Off to On, if it is off screen, set it to either the top or bottom of
screen, depending on which direction off screen it was.
The Display Line's value does not change when it is turned off.
Saved in instrument state.
–∞ (minus infinity) in current units
+∞ (plus infinity) in current units
Prior to A.02.00
Depends on the current selected Y axis unit
or
Restore System Defaults
View/Display, Display
Prior to A.02.00
Off
View/Display, Display, System Display Settings
:DISPlay:WINDow[1]:ANNotation[:ALL] OFF|ON|0|1
:DISPlay:WINDow[1]:ANNotation[:ALL]?
:DISP:WIND:ANN OFF
On (Set by Restore Misc Defaults)
under System.
settings to be
and
Active Function Values
. When
Local Settings
View/Display
All Off
, it forces
Screen
for all measurements in
OFF
keys under the
Display,
is selected, you are able to set
619