Trace (+State) - Agilent Technologies X Series Manual

Key Path
Mode
Notes
Initial S/W Revision
Save
Saves all of the State of the currently active mode plus the system level Input/Output settings to the
specified file.
While the save is being performed, the floppy icon shows up in the settings bar near the
Continuous/Single sweep icon. After the save completes, the Advisory Event "File <register number>
saved" is displayed.
Key Path
Mode
Remote Command
Example
Notes
Backwards Compatibility SCPI
Initial S/W Revision

Trace (+State)

Selects a state file which includes trace data for recalling as the save type and accesses a menu that
enables you to select which trace to save. You can save to either a register or a file. Not all modes
support saving trace data with the state, and for modes that do, not all measurements do. This key is
grayed out for measurements that do not support trace saves. It is blanked for modes that do not support
trace saves. Saving Trace is identical to saving State except a .trace extension is used on the file instead
of .state, and internal flags are set in the file indicating which trace was saved. You may also select to
save ALL traces.
Save, State
All
Brings up Save As dialog for saving a State Save Type
Prior to A.02.00
Save, State, To File...
All
:MMEMory:STORe:STATe <filename>
:MMEM:STOR:STAT "myState.state" saves the file myState.state on the
default path
If the file already exists, the file will be overwritten. Using the C: drive is
strongly discouraged, since it runs the risk of being overwritten during an
instrument software upgrade. Both single and double quotes are supported for
any filename parameter over remote.
Auto return to the State menu and the Save As dialog goes away.
For a backwards compatibility only, the following parameters syntax is
supported:
:MMEMory:STORe:STATe 1,<filename>
The "1" is just ignored.
The command is sequential.
Prior to A.02.00
System Functions
Save
131