Service Request Enable; Status Byte Query; Trigger - Agilent Technologies X Series Manual

Service Request Enable

This command enables the desired bits of the service request enable register.
The query returns the value of the register, indicating which bits are currently enabled.
Remote Command
Example
Notes
Preset
Min
Max
Status Bits/OPC dependencies
Initial S/W Revision

Status Byte Query

Returns the value of the status byte register without erasing its contents.
Remote Command
Example
Notes
Status Bits/OPC dependencies
Initial S/W Revision

Trigger

This command triggers the instrument. Use the :TRIGger[:SEQuence]:SOURce command to select the
trigger source.
Key Path
Remote Command
Example
Notes
Initial S/W Revision
Chapter 4
*SRE <integer>
*SRE?
*SRE 22 Enables bits 1, 2, and 4 in the service request enable register.
For related commands, see the STATus subsystem and
SYSTem:ERRor[:NEXT]? commands.
0
0
255
Service Request Enable Register (all bits, 0 – 7).
Prior to A.02.00
*STB?
*STB? Returns a decimal value for the bits in the status byte register.
For example, if a 16 is returned, it indicates that bit 5 is set and one of the
conditions monitored in the standard event status register is set.
See related command *CLS.
Status Byte Register (all bits, 0 – 7).
Prior to A.02.00
No equivalent key. See related keys Single and Restart.
*TRG
*TRG Triggers the instrument to take a sweep or start a measurement,
depending on the current instrument settings.
See related command :INITiate:IMMediate.
Prior to A.02.00
Programming the Analyzer
IEEE Common GPIB Commands
103