Agilent Technologies X Series Manual page 438

Input/Output
Recorded Data
Directs the instrument to get data from the record data buffer in the measurement, rather than from the
RF Input Signal.
Key Path
Example
Notes
Dependencies
Readback
Initial S/W Revision
Current Meas -> Capture Buffer
Pressing this key stores the raw data of one measurement in the internal memory of the instrument where
it can then be used by a different measurement by pressing "Stored Data". When raw data is stored, then
the data source selection switch automatically changes to "Stored Data". Stored raw data cannot be
directly accessed by a user. There is no save/recall function to save the raw data in an external media.
However if you want to get the stored raw data, you must first perform a measurement using the stored
raw data. Now you can access the used raw data, which is the same as stored raw data, using the FETch
or READ commands.
Key Path
Remote Command
Example
Notes
Dependencies
Backwards Compatibility SCPI
Initial S/W Revision
Record Data Now
This causes the data source to change to Inputs (if it is not already set) and a recording is made with the
current instrument setup. The length of the recording must be specified in advance.
This key changes to
Abort Recording
recording is complete.
The following dialogs show the progress of the recording:
438
Input/Output, Data Source
FEED:DATA REC causes the measurement to extract data from the record
data buffer.
Does not auto return.
Grayed out in the SA measurement.
Recorded Data
Prior to A.02.00
Input/Output, Data Source
[:SENSe]:FEED:DATA:STORe
FEED:DATA:STOR stores recorded data
This is command only, there is no query
Grayed out in the SA measurement.
[:SENSe]:FEED:SOURce:STORe
Prior to A.02.00
once the recording process has started. It changes back when the