Meas Setup; Avg/Hold Num - Agilent Technologies X Series Manual

Complex Spectrum Measurement

Meas Setup

Meas Setup
Opens the menu that allows you to set up the measurement parameters.
Key Path
Initial S/W Revision

Avg/Hold Num

Sets the number of 'sweeps' that are averaged. After the specified number of 'sweeps' (average counts),
the averaging mode (terminal control) setting determines the averaging action.
Key Path
Mode
Remote Command
Example
Notes
Preset
State Saved
Min
Max
Initial S/W Revision
242
Front-panel key
Prior to A.02.00
Meas Setup
BASIC
[:SENSe]:SPECtrum:AVERage:COUNt <integer>
[:SENSe]:SPECtrum:AVERage:COUNt?
[:SENSe]:SPECtrum:AVERage[:STATe] ON|OFF|1|0
[:SENSe]:SPECtrum:AVERage[:STATe]?
SPEC:AVER:COUN 10
SPEC:AVER:COUN?
SPEC:AVER 0
SPEC:AVER?
You must be in the IQ Analyzer (Basic) mode to use this command. Use
INSTrument:SELect to set the mode.
25
ON
Saved in instrument state.
1
20001
Prior to A.02.00