Global Settings; Global Center Freq - Agilent Technologies X Series Manual

Mode
Example
Initial S/W Revision
EMI Receiver Aliases (Remote Command Only)
The following commands are translated to the specified X-Series instrument commands, in order to
emulate EMI Receiver products from other manufacturers
Example
Notes
Initial S/W Revision
Example
Notes
Initial S/W Revision

Global Settings

Opens a menu that allows you to switch certain Meas Global parameters to a Mode Global state. These
switches apply to all Modes that support global settings. No matter what Mode you are in when you set
the "Global Center Frequency" switch to on, it applies to all Modes that support Global Settings.
Key Path
Initial S/W Revision

Global Center Freq

The software maintains a Mode Global value called "Global Center Freq".
When the
Global Center Freq
is copied into the Global Center Frequency, and from then on all modes which support global settings
use the Global Center Frequency. So you can switch between any of these modes and the Center Freq
will remain unchanged.
514
INST:SEL VSA89601
INST:NSEL 101
Prior to A.02.00
INST:SEL SANalyzer
When this command is received, the analyzer aliases it to the following:
INST:SEL SCPILC
This results in the analyzer being placed in SCPI Language Compatibility
Mode, in order to emulate the ESU Spectrum Analyzer Mode.
A.07.00
INST:SEL RECeiver
When this command is received, the analyzer aliases it to the following:
:INST:SEL EMI
:CONF FSC
This results in the analyzer being placed in the EMI Receiver Mode, running
the Frequency Scan measurement, in order to emulate the ESU Receiver
Mode.
A.07.00
Front Panel Key
Prior to A.02.00
key is switched to in any mode, the current mode's center frequency
On