Configuring 802.11B/G Radio Communications; Configuring Bluetooth Communications - Intermec CN4 User Manual

Chapter 2 — Connecting and Configuring the CN4

Configuring 802.11b/g Radio Communications

Configuring Bluetooth Communications

42
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.
Your CN4 has an 802.11b/g radio to transfer data using wireless
communications and supports the TCP/IP network protocols. This
section of the manual assumes that your wireless network is set up,
including your access points.
To use wireless communications in a TCP/IP network
1 Configure these parameters on each CN4 in the network:
• Network name (SSID)
IP settings (if not using DHCP)
•
2 Make sure your CN4 is talking to the network and that the
network can see your CN4.
3 Configure security. For help, see
Security" on page 48.
Your CN4 is Bluetooth™ enabled, which lets you connect to other
Bluetooth devices, such as scanners, printers, or audio devices.
You need to turn on the Bluetooth radio before you can discover and
connect to other Bluetooth devices. By default, the radio is turned off.
To turn on the Bluetooth radio
1 Tap Start > Settings > the Connections tab > Bluetooth > the
Mode tab.
2 Tap Turn on Bluetooth.
"Configuring Wireless
CN4 Series Mobile Computer User's Manual