Table of Contents
Advertisement
5.17.5
Cab Display Module (CDM)
Programming
The monitoring system requires programming
for each header and the header must be
attached to the tractor.
system may be accomplished with or without the
engine running.
If the engine is running, the
transmission must be in neutral. If the engine is
not running, the ignition must be on.
programming mode can be exited at any time by
pressing the PROGRAM switch or by turning off
the ignition.
The system only needs to be
SIDE DISPLAY
Displays Software Revision Status
Upper Line – D### (CDM)
Lower Line – C### (WCM)
PROGRAM SWITCH
Places Monitor Into Program Mode
Press While Depressing SELECT Switch
Press To Exit Program Mode.
* Fast Scroll Applies Only When Changing Knife Speed, Overload Pressure, and Tire Size.
Form 169017
OPERATOR'S STATION
Programming the
The
MENU ITEM SCROLL BACKWARD
Displays Value Under Menu Item
Push To Scroll Backward.
Keep Depressed For Fast Scroll. *
41
programmed once for each header unless the
operator needs to change a particular setting to
suit windrowing conditions or modifications to
the machine.
Most functions have been pre-
programmed at the factory but can be changed
by the operator if required.
NOTE
Contact
your
dealer
regarding
software
electronic modules. Your dealer will have
the necessary interface tools and access
to the latest software upgrades.
Displays Menu Item and Selection
Upper Line – Menu Item
Lower Line - Selection
Places Monitor Into Program
Mode With PROGRAM SWITCH
Press to Accept Menu Item and
Advance to Next Item.
MENU ITEM SCROLL FORWARD
Displays Value Under Menu Item
Push To Scroll Forward.
Keep Depressed For Fast Scroll. *
for
information
updates
to
the
MAIN DISPLAY
SELECT SWITCH
Issue – June 2008
Advertisement
Table of Contents
