CHANGING PRINTER DEFAULTS
Factory presets can be changed via the Settings page. To access this page, press the Settings button within the
Navigation Bar.
DISPLAY UNITS
By default the printer is configured to display English (imperial) units (inches). However, you can adjust this
setting as needed to have the printer display metric units.
The Units setting determines the type of units that the printer is configured for, English or Metric. To configure
this setting, use the slider graphic to select between English and Metric units.
Figure 5-28:
JOB STORAGE
The Keep Previous Job setting determines whether or not the printer's previous job is stored within the Job
Queue once a build is complete (see
your printer seeing what you've built, this setting will prevent the printer's previous job from being accessible
after the build is complete. By default this setting is set to On meaning that the printer's previous job file is stored
within the Job Queue making it available for re-selection upon completion of the build.
When this setting is set to Off, the printer's previous job file will be deleted from the Job Queue upon completion
of the build. The job's file will need to be resent to the printer in order to be built again.
To configure this setting, use the slider graphic to turn the setting On and Off as needed.
Figure 5-29:
Units
"Keep Previous Job" on page
Keep Previous Job
87). If you're concerned about other users of
175