Change Modeler Default Values; Display Units; Part Build Location - Stratasys Fortus 360mc User Manual

CHANGE MODELER DEFAULT VALUES

Factory presets can be changed from the
1. From the Main Menu select
2. Select
Modeler Default..

DISPLAY UNITS

Select
Display Units

PART BUILD LOCATION

The part build location can be viewed or changed from the
to toggle between
YES
1. If User Placement is set to
2. If User Placement is set to
imaginary box surrounding the part - used by the modeler to define part placement on the platen)
can be viewed or changed from the following menu:
Note: This menu is displayed when a part is sent to build (refer to
to Build" on page
A. To change the start location, select
Modeler Default..
Maintenance
Build Job..
Operator Control..
Modeler Status..
>Maintenance..
and press ENTER.
>Modeler Default..
Administration..
Reboot system..
Measure Flatness <E>
. Inches or metric can be selected (factory setting is in inches)
> Display Units = in (Inches)
User Placement on Platen:
and ).
NO
(default) - the part will build in the center of the platen.
NO
- the position of the front, left corner of the bounding box (the
YES
34).
>Locate Part Start..
Demo Bounding Box <E>
Continue..
* * * Use the 2, 4, 6, 8 Keys * * *
Press 1: Coarse Moves: 1.000
>Press 0: Fine Moves:
* * * Press ENTER to Set New XY Start * * *
menu.
and press ENTER.
|*Tips: Model T16
|* Support T16
<E>
No
User Placement on Platen
Locate Part Start..
0.100
54
menu (press ENTER
"Select a Job
and press ENTER.
in
in