OVEN THERMISTOR
Required Tools
3 mm hex wrench
•
Removing the Oven Thermistor
1.
Power OFF the printer. See
2.
Remove the rear panel. See
3.
Remove the right rear side panel. See
4.
Disconnect the thermistor cable from the I/O board (J36).
5.
Use a 3mm hex wrench to remove the mounting screw (1) that secures the thermistor to the oven
wall. See
Figure
6.
Remove the thermistor from the printer. See
Figure 7-17:
Installing the Oven Thermistor
1.
Align the oven thermistor with its mounting location and use a 3 mm hex wrench to reinstall the
mounting screw (1). See
2.
Route the oven thermistor wire through the printer and reconnect it to the I/O board (J36).
3.
Reinstall the right rear side panel. See
4.
Reinstall the rear panel. See
"Powering Off" on page
"Removing the Rear Panel" on page
7-17.
Thermistor Detail
Figure
7-17.
"Installing the Rear Panel" on page
169.
"Right and Left Side Panels" on page
Figure
7-17.
"Installing the Side Panels" on page
176
170.
171.
172.
170.