Oven Thermistor - Stratasys F120 User Manual

Customer Replaceable Units
5. Reconnect the input power cable to the 3.3/5/12 VDC ATX power supply.
6. Make sure that the switch on the power supply is in the ON position.
7. Reinstall the right side panel. See
8. Reinstall the rear panel. See

Oven Thermistor

Required Tools
• 3 mm hex wrench
Removing the Oven Thermistor
1. Power OFF the printer. See
2. Remove the rear panel. See
3. Remove the right side panel. See
4. Disconnect the thermistor cable from the I/O board (J36).
5. Use a 3mm hex wrench to remove the mounting screw (1) that secures the thermistor to
the oven wall. See
6. Remove the thermistor from the printer. See
Installing the Oven Thermistor
1. Align the oven thermistor with its mounting location and use a 3 mm hex wrench to reinstall
the mounting screw (1). See
2. Route the oven thermistor wire through the printer and reconnect it to the I/O board (J36).
"Installing the Side Panels" (page 164)
"Installing the Rear Panel" (page
"Powering Off" (page
"Removing the Rear Panel" (page
"Removing the Side Panels" (page
Figure 23.
Figure 23: Thermistor Detail
Figure 23.
© Copyright 2020 Stratasys. All rights reserved.
161).
159).
161).
Figure 23.
Oven Thermistor
162).
Page 169