Customer Replaceable Units; Powering Off - Stratasys F170 User Manual
F123 series shared office 3d printers
Hide thumbs
Also See for F170:
- Operation and maintenance manual (91 pages) ,
- Site preparation manual (22 pages)
Table of Contents
Advertisement
CUSTOMER REPLACEABLE UNITS
The following service procedures outline the replacement instructions for the customer replaceable units of the
F123 Series printers.
POWERING OFF
Warning: Make sure AC power is removed from the printer.
Powering OFF the Printer
1.
Depress the Power button (see
2.
Press Accept on the touchscreen display.
3.
Wait approximately 25 seconds for the printer to power down.
4.
Remove the AC power cord from the rear of the system.
Figure 7-10:
Figure 5-1 on page 105
AC power cord location
for button location).
169
Advertisement
Table of Contents
