Table of Contents
Advertisement
12 Installing the Electronic Door Lock System
12.1 Installing the Door Lock (BOM: 02311EYT)
•
When installing an electric lock on a cabinet, adjust the door handle based on the direction in which the door is opened so
that the door can be easily opened.
•
The lock cylinder and lock body of an electronic lock are delivered together. Decide whether to replace the lock cylinder
based on site conditions. If you decide to replace the lock cylinder, refer to
mechanical key properly.
•
When the electronic door lock and battery anti-theft component are configured, the door lock cover in the battery anti-theft
component is scrapped.
•
Dispose of the lock tongue in the attachment of the electronic door lock。
When you open or close the cabinet door using the electric lock, the following may occur if the lock handle lever is not in
position (abutting the lock handle), as shown in figure
position and then swipe the access card again, as shown in figure
Open the cabinet door.
Wear the ESD wrist strap and connect its grounding end to the ESD
jack on the cabinet, or wear ESD gloves.
Remove the HW-2802 lock from the cabinet. For details, see Common
Maintenance Guide for Outdoor Cabinets.
Take out the electronic lock and disassemble the lock to facilitate
subsequent installation.
(Optional) Install the restraint part and jump ring.
The restraint part must be correctly assembled so that the lock
handle moves in the same direction (clockwise or anti-clockwise)
as the opening direction of the door.
Assembled and delivered together
Lock
Lock cover
B
. In this case, you need to press the lock handle lever until it is in
A
M5 screw
M6 screw
Lock tongue
Delivered separately
34
to replace the lock cylinder and keep the
.
Left-right
Restraint part
Clockwise
Lock handle
A
B
"OK"
"NOK"
Up-down
Restraint part
Anti-clockwise
Advertisement
Table of Contents
