Optional) Setting Parameters Before Using Neteco - Huawei MTS9300A Installation Manual

MTS9300A Telecom Power (Claro, Colombia,
MTS9304A-AM10A1)
Installation Guide
Procedure
Step 1 Set the port mode, communications protocol type, baud rate, and communications
address on the SMU's LCD.
Table 8-9 Communications parameters
Main Menu Second-
Level Menu
Parameters Comm.
Settings Parameters
----End

8.10.3 (Optional) Setting Parameters Before Using NetEco

Networking Mode 1: FE Port
Step 1 Apply to the site or equipment room network administrator for a fixed IP address.
Step 2 Set the IP address, subnet mask, and gateway on the SMU's LCD.
Table 8-10 IP parameters
Main Second-Level
Menu Menu
Setting Network
Wizard Parameters
Issue 01 (2021-05-30)
Third- Fourth-Level
Level Menu
Menu
Serial Northbound
Port
M/S Baud Rate
Protocol
Comm.
Address
Third-Level
Menu
IP Address
Subnet Mask
Copyright © Huawei Technologies Co., Ltd.
Fifth-Level
Menu
Port Mode
Protocol
Type
NOTE
Protocol
Type is
displayed
only when
Port Mode is
set to
Manual.
-
-
Default Value Settings
192.168.0.10 Set this parameter
according to the IP address
assigned by the network
administrator.
255.255.255.0 Set this parameter
according to the subnet
mask provided by the
network administrator.
8 Commissioning
Default Settings
Value
Manual Manual
M/S M/S
Protocol Protocol
9600 9600
3 3
65