System Sanitization Commands; Communication Lan Commands - Pacific Power Source ADF Series Operation Manual

8.9.6

System Sanitization Commands

Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
8.9.7

Communication LAN Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
SYSTem:SANITIZE:CODE?
Returns sanitization password string.
<nr1>
SYSTem:SANITIZE:CODE?
0659
SYSTem:SANITIZE <code>
Erases all user data stored in non-volatile memory settings including
settings and custom waveforms if required. The code is obtained by
the query command above.
None
n/a
SYST:SANITIZE 0659
SYSTem:COMMunicate:LAN[:ENABle]
This command turns remote control via LAN on or off. To control the
power source through its LAN interface, this state has to on (1).
< 0 | OFF | 1 ON >
<b>
SYST:COMM:LAN ON
SYSTem:COMMunicate:LAN[:ENABle]?
SYST:COMM:LAN?
1
SYSTem:COMMunicate:LAN:STATus?
This command returns all LAN settings in a single comma delimited
string of values.
<cr>, <cr>,.....,<cr>,<cr>
SYSTem:COMMunicate:LAN:STATus?
192.168.14.22,255.255.254.0,192.168.15.254,192.168.15.208,ADF-
106378937,ADF-106378889,0,1,0
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 230 of 349