Communication Gpib Commands - Pacific Power Source ADF Series Operation Manual

8.9.10 Communication GPIB Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
SYSTem:COMMunicate:GPIB:ADDress <nr1>
This command sets the GPIB address.
< 1..30 >
<nr1>
SYST:COMM:GPIB:ADD 5
SYSTem:COMMunicate:GPIB:ADDress?
<nr1>
SYST:COMM:GPIB:ADD?
5
SYSTem:COMMunicate:GPIB:ENABle
Enables access to embedded webserver using virtual IP Address
through USB interface.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:GPIB:EANB 1
SYSTem:COMMunicate:GPIB:ENABle?
<b>
SYST:COMM:GPIB:ENAB?
1
SYSTem:COMMunicate:GPIB:BAUDrate
Sets the internal serial link speed between the GPIB interface and the
front panel processor. This setting is set to 921600 bps as a default
and should only be changed to a lower setting if there is a problem
with the GPIB interface not working reliably.
< 1200 | 1800 | 2400 | 4800 | 9600 | 14400 | 19200 | 38400 | 57600 |
62500 | 115200 |230400 | 460800 |500000 | 576000 | 921600 >
<nr1>
SYST:COMM:GPIB:BAUD 921600
SYSTem:COMMunicate:GPIB:BAUDrate
<nr1>
SYST:COMM:GPIB:BAUD?
921600
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
?
Page 237 of 349