Pacific Power Source ADF Series Operation Manual page 231

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
SYSTem:COMMunicate:LAN:DHCP[:ENABle]
This command turns DHCP mode for the LAN interface on or off.
DHCP = Dynamic Host Configuration Protocol". This protocol
automatically provides an IP address and other related information
such as the subnet mask and default gateway.
When turned off, a static IP address must be assigned by the user
instead.
< 0 | OFF | 1 | ON >
<b>
SYST:COMM:LAN:DHCP ON
SYSTem:COMMunicate:LAN:DHCP[:ENABle]?
<b>
SYST:COMM:LAN:DHCP?
1
SYSTem:COMMunicate:LAN:DHCP:RENEW
This command renews the lease of an IP address assigned through
the DCHP protocol. This may be necessary if the power source has
not been used in a while and its IP address lease has expired. If not
renewed, a different IP address may be assigned.
None
n/a
SYST:COMM:LAN:DHCP:RENEW
SYSTem:COMMunicate:LAN:ADDress
This command is used to assign a fixed IP address to the power
source for LAN communication.
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:ADD 132.18.21.105
SYSTem:COMMunicate:LAN:ADDress?
<cr>
SYST:COMM:LAN:ADD?
132.18.21.105
SYSTem:COMMunicate:LAN:MACaddress?
This query returns the MAC address of the connected power source.
The Media Access Control address or MAC address is also referred to
as physical address as it is fix and unique to any device on the
network.
The MAC address for the power source is also printed on the rear
panel near the LAN interface connector. It consists of 8 sets of
hexadecimal 16 bit unsigned integer values.
<cr>
SYST:COMM:LAN:MAC?
3A.3F.00.4C.DE.AA.39.8F
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 231 of 349