Pacific Power Source ADF Series Operation Manual page 340

Error Source Code
Front panel 504
Front panel 505
Front panel 506
Front panel 507
Front panel 508
Front panel 509
Front panel
510
Front panel
511
Front panel 512
Front panel 513
Front panel 514
Front panel 515
Front panel 516
Front panel 517
Front panel 518
Front panel 519

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
Category Error Message
Error Cannot change extended
voltage mode with output
enabled.
Error Cannot enable current
overload mode when
extended voltage range is
enabled.
Error Cannot enable extended
frequency when
extended voltage range is
enabled.
Warning Power limits were
reduced due to extended
frequency mode.
Warning Current limits were
reduced due to extended
frequency mode.
Error Setpoint out of range due
to extended frequency
mode."
Unable to update
Error
setpoint because it is
outside the allowed range
of extended frequency
mode.
Error during power stage
Error
firmware update.
Error Phase rotation is always
negative in UPC
compatible mode.
Error Cannot change split
phase mode with output
enabled.
Error Serial port flow control
not available in this unit.
Error Too many commands per
line.
Warning Resistive impedance was
automatically reduced.
Warning Inductive impedance was
automatically reduced.
Error Cannot change output
impedance state with
output enabled.
Error Cannot change output
impedance mode with
output enabled.
ADF SERIES™ OPERATION MANUAL
Service and Maintenance
SECTION 13:
Possible Cause Resolution
Page 340 of 349