Pacific Power Source ADF Series Operation Manual page 203

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]VOLTage:DC#:SLEW
Sets DC voltage slew rate for phase #. If # is omitted, sets all available
phases to value specified.
Note: Source must be in DC or AC+DC mode and UPC compatibility
mode must be disabled.
Range 0.01- 850.00
<nr2> and <nr3>
VOLT:DC1:SLEW 850.00
[SOURce:]VOLTage:DC#:SLEW?
<nr2>
VOLT:DC1:SLEW?
850.0000
[SOURce:]VOLTage:DC#:LIMit:MINimum
Sets low user limit for DC voltage programming for phase #. If # is
omitted, sets all available phases to value specified. User limits must
fall within actual hardware limits of the power source. Also, MIN limit
must be less than MAX limit.
-425.0 – 425.0
<nr2>
VOLT:LIM:DC1:MIN 20.0
[SOURce:]VOLTage:DC#:LIMit:MINimum?
<nr2>
VOLT:DC1:LIM:MIN?
-425.000
[SOURce:]VOLTage:DC#:LIMit:MAXimum
Sets upper user limit for DC voltage programming for phase #. If # is
omitted, sets all available phases to value specified. User limits must
fall within actual hardware limits of the power source. Also, MIN limit
must be less than MAX limit.
-425.0 – 425.0
<nr2>
VOLT:LIM:DC1:MAX 270.0
[SOURce:]VOLTage:DC#:LIMit:MAXimum?
<nr2>
VOLT:DC1:LIM:MAX?
-425.000
[SOURce:]VOLTage:DC#:LIMit:RANGe?
This query returns both upper and lower user limits for DC voltage
programming.
<nr2>,<nr2>
VOLT:DC1:LIM:RANG?
-425.0000,425.0000
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 203 of 349