Pacific Power Source ADF Series Operation Manual page 242

SYSTem:DIO
:INput[1 | 2 | 3 |.4][?]
:OUTput[1 | 2 | 3 |.4][?]
:REMote
:STROBE
8.10.1.1 SYSTem:AIO:Input
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
:FALLing[?]
:FILtersize[?]
:DEFault?
:MAXimum?
:MINimum?
:RISing[?]
:CATalog?
:INVert[?]
:STATe?
:ENAble[?]
:INHibit[?]
:OUTPutstate[?]
:SOURce[?]
:TRANsient[?]
SYSTem:AIO:INput[n] <cr>
Sets the ADF parameter to be controlled by the analog input.
[ CURR:LIM | CURR:LIM1 | CURR:LIM2 | CURR:LIM3 | FREQ |
KVA:LIM | KVA:LIM1 | KVA:LIM2 | KVA:LIM3 | OFF | PHAS2 | PHAS3
| POW:LIM | POW:LIM1 | POW:LIM2 | POW:LIM3 | VOLT:AC |
VOLT:AC1 | VOLT:AC2 | VOLT:AC3 | VOLT:DC | VOLT:DC1 |
VOLT:DC2 | VOLT:DC3 ]
See the "SYSTem:AIO:INput:CATalog?" command response for a list
of supported parameters.
<cr>
SYST:AIO:IN1 VOLTAGE
SYSTem:AIO:INput[n]?
<cr>
SYST:AIO:IN1?
VOLTAGE
SYSTem:AIO:INput:CATalog?
Returns list of available analog inputs
<cr>
SYST:AIO:IN:CAT?
CURR:LIM,CURR:LIM1,CURR:LIM2,CURR:LIM3,FREQ,KVA:LIM,KVA:LIM
1,KVA:LIM2,KVA:LIM3,OFF,PHAS2,PHAS3,POW:LIM,POW:LIM1,POW:L
IM2,POW:LIM3,VOLT:AC,VOLT:AC1,VOLT:AC2,VOLT:AC3,VOLT:DC,VOL
T:DC1,VOLT:DC2,VOLT:DC3
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 242 of 349