Pacific Power Source ADF Series Operation Manual page 258

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
PROGram:TRANsient:TRIGger:INput:AUTOrun <b>
When the trigger input is active and segments are running state, each
trigger event (pulse) will automatically start a new sequence, without
the need of a new RUN command before each trigger. The RUN
command has to be executed only once, and then each subsequence
trigger input event will cause a new segment sequence to run.
Note: the trigger signal is level-sensitive; hence if it is kept high,
it will continuously issue a trigger.
[ 0 | OFF | 1 | ON ]
<b>
PROG:TRAN:TRIG:IN:AUTO 1
PROGram:TRANsient:TRIGger:INput:AUTOrun?
<b>
PROG:TRAN:TRIG:IN:AUTO?
1
PROGram:TRANsient:TRIGger:OUTput
This command causes a trigger output pulse to be generated when a
transient execution is started. Note that this output is used as a
function strobe during steady state operation.
[ 0 | OFF | 1 | ON ]
<b>
PROG:TRAN:TRIG:OUT 1
PROGram:TRANsient:TRIGger:OUTput?
<b>
PROG:TRAN:TRIG:OUT?
1
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 258 of 349