Pacific Power Source ADF Series Operation Manual page 208

Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]CURRent:LIMit#:MAX?
This command returns the maximum available programmable current
limit setting. Note that the returned value is a function of the
"SYSTem:COMPatible" setting
UPC If UPC mode is enabled, this command always returns 2000.0000 to
emulate the UPC controllers
DISABLED With UPC mode disabled, this command returns the max. available
current output per phase. This value is a function of the ADF model
and the number of units that are connected in parallel.
<nr2>
CURR:LIM:MAX?
41.6667
[SOURce:]CURRent:LIMit#:DEFault?
This command returns the default current limit setting at power up
for the referenced phase.
<nr2>
CURR:LIM1:DEF?
41.67
[SOURce:]CURRent:LIMit#:MAXimum?
This command returns the maximum current limit setting available
for the referenced phase.
<nr2>
CURR:LIM:MAX1?
41.67
[SOURce:]CURRent:LIMit#:MINimum?
This command returns the minimum current limit setting available for
the referenced phase.
<nr2>
CURR:LIM:MIN1?
0.000
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 208 of 349