Voltage Protection Programming Commands - Pacific Power Source ADF Series Operation Manual

8.7.6

Voltage Protection Programming Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Query Example
Query Syntax
Description
Query Example
Query Syntax
Description
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]PROTect:PEAK:VOLTage:MODE <MARGin|LEVel|BOTH>
This command sets the maximum voltage peak margin. If the output
voltage peak exceeds the programmed peak level by more than this
amount, an error is tripped.
<MARGin | 0 | LEVel | 1 | BOTH | 2 >
Encoding:
MARGin 0
LEVel 1
BOTH 2
<cr> | <nr1>
PROT:PEAK:VOLT:MODE BOTH
[SOURce:]PROTect:PEAK:VOLTage:MODE?
<nr2>
PROT:PEAK:VOLT:MODE?
2
[SOURce:]PROTect:PEAK:VOLTage:MARGin <VOLTAGE MARGIN>
This command sets the maximum voltage peak margin. If the output
voltage peak exceeds the programmed peak margin by more than
this amount, an error is tripped.
<VOLTAGE MARGIN>
<nr2>
PROT:PEAK:VOLT:MARG 120.0
[SOURce:]PROTect:PEAK:VOLTage:MARGin?
<nr2>
PROT:PEAK:VOLT:MARG?
120.000
[SOURce:]PROTect:PEAK:VOLTage:MARGin:MINimum?
This command returns the minimum voltage peak margin setting.
PROT:PEAK:VOLT:MARG:MIN?
0.000
[SOURce:]PROTect:PEAK:VOLTage:MARGin:MAXimum?
This command returns the maximum voltage peak margin setting
PROT:PEAK:VOLT:MARG:MAX?
500.000
[SOURce:]PROTect:PEAK:VOLTage:MARGin:DEFault?
This command returns the default voltage peak margin setting
PROT:PEAK:VOLT:MARG:DEF?
100.000
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Relative level
Absolute level
Both
Page 211 of 349