Pacific Power Source ADF Series Operation Manual page 170

Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
CALibrate:COEFFicients:GAIN:VOLTage[:AC] <cr>
Loads values measured with an external DVM for calibration of AC
voltage output and metering.
The first 3 values are Voltages measured at the output relay of the
power source for each phase.
The second set of 3 values are Voltages measured at the external
voltage sense points (at the load) for each phase.
External reference voltage readings for each phase
n/a
n/a
CALibrate:COEFFicients:GAIN:CURRent[:AC] <cr>
Loads values measured with an external shunt and DVM for
calibration of AC current metering.
The first 3 values are currents measured at the output of the power
source for each phase.
External reference current reading
n/a
n/a
No
n/a
n/a
CALibrate:RESET
Clears all calibration coefficients. Sending this command resets all
calibration factors to defaults. After sending this command,
programming and metering remains functional and will still meet
spec.
None
n/a
CAL:RESET
CALibrate:COEFFicients:ALL?
Returns all eighteen calibration factors as a comma delimited list.
<nr1>,...,<nr1>
CAL:FACT:ALL?
0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0
CALibrate:UPDATE
Transfers cal factors from XML Calibration file to NVM. Required only
if calibration.xml has been modified. Alternatively, the unit can be
power cycled.
None
n/a
n/a
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 170 of 349