Pacific Power Source ADF Series Operation Manual page 264

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Returned Data Format
Query Example
Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
*ESE<nr1>
Selects the desired bits from the standard event status enable
register. The variable <nr1> represents the sum of the bits that will
be enabled.
This register monitors I/O errors and synchronization conditions such
as operation complete, request control, query error, device
dependent error, status execution error, command error and power
on. The selected bits are OR'd to become a summary bit (bit 5) in the
byte register which can be queried. The setting by this command is
not affected by *RST. However, cycling the power will reset this
register to zero. Refer to section 8.12 for register bit values.
Range 0-255
<nr1>
*ESE 128
*ESE?
<nr1>
*ESE?
193
*ESR?
Event Status Register Query. Reads the contents of the Status Event
Register (ESR). After this query, the content of the ESR register is
reset. Refer to section 8.12 for register bit values.
<nr1>
*ESR?
0
*GTL
Goto Local. Releases lock of front panel controls.
N/A
N/A
*IDN?
Identification Query. Returns the unit's Identity string. The IDN string
response contains several fields separated by a comma.
Query response: Manufacturer, model, serial number, firmware
revision.
<cr>,<cr>,<nr1>,<nr2>
*IDN?
PPSC,3150ADF-4,106378889,2.0.0
*LLO
Local Lock out. Locks out front panel LOCAL function.
None
n/a
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 264 of 349