Pacific Power Source ADF Series Operation Manual page 233

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
SYSTem:COMMunicate:LAN:HOST:CONFigured
Sets the network host address. The host address is the portion of the
address used to identify hosts (any device requiring a Network
Interface Card, such as a PC or networked printer) on the network.
The network ID, by contrast, is the portion of the address that refers
to the network itself.
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:HOST 132.18.21.0
SYSTem:COMMunicate:LAN:HOST:CONFigured?
<cr>
SYST:COMM:LAN:HOST:CONF?
132.18.21.0
SYSTem:COMMunicate:LAN:PASSword
Assign a password to enable or disable LAN communications. This
feature allows the owner/operator to disable or enable remote LAN
access or limit functionality over LAN.
Note: There is no query format for this command so the password
code cannot be queried back.
Four digit passcode
<nr1?
SYST:COMM:LAN:PASS 1234
SYSTem:COMMunicate:LAN:PORT
Sets LAN interface port address. For SCPI message communications,
the standard port number is 5025.
1024–49151, default = 5025
<nr1>
SYST:COMM:LAN:PORT 5025
SYSTem:COMMunicate:LAN:PORT?
<nr1>
SYST:COMM:LAN:PORT?
5025
SYSTem:COMMunicate:LAN:PORT:TELNET
Sets the port address for TELNET protocol
1024–49151, default = 5024
<nr1>
SYST:COMM:LAN:PORT:TELNET 5024
SYSTem:COMMunicate:LAN:PORT:TELNET?
<nr1>
SYST:COMM:LAN:PORT:TELNET?
5024
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 233 of 349