Pacific Power Source ADF Series Operation Manual page 197

Command Syntax
Description
[SOURce:]INITial? = ON
[SOURce:]INITial? = OFF
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]INITial <n>
Sets source output settings initialization mode. This command in
combination with the "OUTPut[:STATe]:AUTO" command allows the
unattended resumption of a test station after a power failure.
Note: This condition is potentially hazardous and should be used
with caution.
Set points of the unit at power on will be the last set after power off.
The set points affected by this command are:
- Frequency
- Voltage AC1
- Voltage AC2
- Voltage AC3
- 0
- 0
- 0
- Form (THREE , SPLIT or SINGLE)
- Range (High or Low)
- Compatibility Mode (UPC or NORMAL)
Set points of the unit at power on will have a default value of:
- Frequency = 60Hz
- Voltage AC1 = 0V
- Voltage AC2 = 0V
- Voltage AC3 = 0V
- 0
- 0
- 0
- Form = THREE
- Range = HIGH
- Compatibility = NORMAL
< 0 | OFF | 1 | ON >
<b>
:INIT ON
[SOURce:]INITial?
<b>
INIT?
0
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 197 of 349